Finding The Best Appliances

« Back to Home

How To Correct A Bad Seal On Your Washing Machine

Posted on

Do you find unexplained wet spots in front of your washer after you do a load of laundry? If you notice this, it's possible that the water is coming from your washing machine due to a bad seal. A bad seal can waste a lot of water, and it can also reduce the effectiveness of your machine. A wet floor can also be quite dangerous when you're dealing with electrical appliances.

If you notice that your washing machine is leaking, you should replace the seal as quickly as possible. You can either call a washer repair expert or handle the job on your own.

Unplug the Machine First

Before anything else, ensure that the washing machine is disconnected from the electricity. Doing any kind of work on an appliance that's connected to power is a bad idea.

Remove the Front Panel

To access the seal at the front of your washing machine, you'll need to unscrew the front panel first. Unfortunately, this isn't possible with al washing machines. Therefore, you may have to unscrew and remove the lid and even the door hinge where possible.

Remove the Retaining Band

The outer edge of your door seal is likely to be fitted with a small band. Lift this seal gently with a flat-head screwdriver and pull it off the seal.

Removing the Door Seal

Removing the door seal will require a bit of care. Use your fingers or the screwdriver to pry the seal from the drum. You'll need to watch out for any clips that may be holding the seal in place. These may need to be removed with a screwdriver.

Remove the Retaining Band or Spring

This is the part that holds the rubber seal in place. Loosen the nut or screw holding the spring in place. This will allow the seal to be unhooked. Depending on your machine, you may need to remove the lid of the washing machine or remove the front panel. Note the position of the drain holes and ensure the new seal has holes in a similar position.

Putting in the New Seal

Clean the location of the seal before you put in the new one. You may need to use a sealant to lubricate the seal when you install it. Ensure holes in the seal are properly aligned when replacing the seal. Reattach the other parts in the same order you removed them.

For more information, reach out to companies like Eco Appliance Service.


Share